Most accurate power analyser focusses on transformer testing

February 23, 2017 //By Graham Prophet
Most accurate power analyser focusses on transformer testing
Yokogawa's WT3000E Transformer Version is presented as the most accurate precision power analyser dedicated to testing the power transformers used in the utilities’ transmission and distribution sectors. Basic accuracy of 0.01% offers transformer manufacturers potential cost savings of thousands of euros, Yokogawa asserts

With an accuracy of 0.5% at power factors as low as 0.01 at 100V and 1A, the WT3000E Transformer Version is suited to the precision testing of transformer losses, allowing transformer manufacturers to avoid potential fines imposed by power authorities.


“When every kilowatt lost beyond specified limits can cost thousands of dollars in fines, it is vital to have confidence in the measurement of power losses, particularly under no-load conditions and at power factors as low as 0.01”, says Terry Marrinan, Vice-President, T&M Business Unit, Yokogawa T&M Europe and Asia Pacific: “To address this challenge, the WT3000E Transformer Version is calibrated at power factors of 1, 0.5, 0.05, 0.01 and 0.001 to enable engineers in transformer testing to accurately capture and measure any drift outside the limits described in the IEC60076-8 Standard.” As a result, the WT3000E Transformer Version further exceeds the requirements for accuracy in the standard at a power factor of 0.01 and is now also specified down to a power factor of 0.001.


The WT3000E Transformer Version maintains high levels of accuracy over a wide range of power factors. The ±0.01% total power accuracy figure applies at a power factor of 1 and a frequency of 44-66 Hz. The corresponding value for power factors in the range 0.02 to 0.01 is 0.5%, and for power factors in the range 0.01 to 0.001 it is 7%.


The WT3000E Transformer Version is also a highly stable instrument that offers consistent results without the need for yearly adjustments. Every instrument is supplied with a calibration certificate from Yokogawa’s ISO 17025 accredited calibration laboratory in the Netherlands. As the only ISO 17025 certified non-governmental organisation that offers calibration up to 100 kHz, Yokogawa is equipped to guarantee the specifications of its power meters and improve them with calibration.


The instrument has an intuitive 8.4-inch high-resolution TFT display which can be used to compare up to four waveforms

Vous êtes certain ?

Si vous désactivez les cookies, vous ne pouvez plus naviguer sur le site.

Vous allez être rediriger vers Google.